For the decal diy'ers

There's nothing like the sense of accomplishment you get from completing a task that you're generally supposed to "leave to the experts"!  When it comes to vehicles? Absolutely, let us handle that! But today, we're going to give you a quick lesson in installing wall/window decals so that you feel prepared and confident installing them on your own after ordering from Direct Effect Wraps. 

First, you'll want to gather your supplies:
- Cleaner/rubbing alcohol (Depending on the surface type.)
- Lint-free cloth
- Measuring tape
- Painter's or masking tape
- Squeegee (A plastic card works well in a pinch.)
- Utility blade or knife
- Decal 
Next, follow these simple, step - by - step directions:

1. Step one: Thoroughly wipe down the surfaces with alcohol or cleaner, using a lint-free cloth. 
2. Step two: Measure the length of your decal, subtract that number from the length of surface area you are adhering the decal to. Take that number and divide it by two, this will give you the distance you should alot for on both sides of your decal to ensure equal spacing. 
3. Step three: Using painter's or masking tape, gently tape down the sides of the decal so you can reposition if needed. Once you're happy with the placement, create a "hinge" down the center of the decal to hold it firmly in place. 
4. Step four: Using your knife, just to the inside of the decal, cut the tape that's holding down both sides just to the inside of the decal's edge. (Be sure to only cut through the tape, not into the decal itself!)
5. Step five: Starting on the left, peel the backing off the decal from end to hinge and cut the backing off. Using the tape that's still on the surface as your guide, carefully line it up with the tape remaining on the decals transfer paper. (Always peel at an angle, whether it’s decal from adhesive tape or backing from surface.)
6. Step six: Holding the decal out, begin to squeegee from the center - out, in an up - down sequence, overlapping your last stroke to ensure there are no bubbles. 
7. Step seven: Now, remove your hinge and starting at the center again, pull your paper backing off to expose the other side of your decal. Align the decal with the tape marker on you surface and hold it out without tacking it back down. 
8. Step eight: Using medium pressure and starting at the center, squeegee out to the end of the right side of the decal in the same up - down motion as before. 
9. Step nine: Now that the entire decal is firmly adhered to your surface, carefully scrape the top right- hand corner with your knife to lift the transfer paper. 
10. Step ten: At a 40 or 180 degree angle, slowly remove the transfer paper completely to expose your decal! 

Simple as that, and you're done! 
Whether you need branding for your business, decor for your walls or a simple graphic on your vehicle, we want to enable you to get it done.